Can You Jump a Moped With a Car
College students and commuters are now using scooters as their preferred method of transportation for travelling short distances. Scooters have the advantage of not using a large amount of fuel. They use a battery as their primary power source and contain starting systems that are powered using electricity. The batteries that are used in scooters are made so they are able to be charged up and hold that charge consistently. However, as time goes by, these batteries can begin to lose this capacity. When this starts to happen, the battery will no longer contain the necessary cranking amps for it to successfully start the gas engine. If you are not able to start the scooter by the conventional method, a jump-start will be required.
Safety Precautions
Be certain that all of the necessary safety precautions are taken when you are in the process of jump-starting the battery. You should always protect your hands from possible injury by wearing thick and durable work gloves. Always wear safety goggles to keep your eyes protected. Make sure the scooter is always kept far away from all sources of heat, especially open flames. A cigarette would also fall into this category. While the charging process is underway, battery acid can begin to leak. Use a towel to cover the battery once you have finished connecting the terminals. This will stop the acid from coming into contact with your skin.
Accessing the Battery Compartment
You will find the battery under the footrest or under the seat. Read your owner's manual to find out exactly where your battery is located. For batteries that are located close to the fuel tank, it will be necessary for you to take off the seat in order to get access to the battery. If your battery can be found under your footrest, the battery cover can be accessed by lifting the rubber mat. Open the disconnect clamps or take out the screws that hold the battery cover in place to get into the compartment where the battery is located.
Starting a Scooter with a Jump Pack
Determine which terminals are negative and positive on the jump pack and the battery of the scooter. A negative terminal is black and a positive terminal is red. Before you connect the battery terminals of the scooter to the cables, make sure you set the battery pack to 12 volts. Always be certain to connect the negative terminals before the positive terminals. Start the scooter and after the engine has successfully started, remove the negative cable first.
Jump-starting a Scooter with a Vehicle
A car is able to be used to start a scooter if no battery pack can be found. Jumper cables can be used to connect the negative terminals first, followed by the positive terminals. The dead battery should first be connected to the cables. By having the vehicle turned off, the possibility of damaging your scooter can be reduced. The scooter should be started by the cranking power of the vehicle battery. Once the scooter has started successfully, remove the negative jumper cable clamps first. The cables should not be kept connected for a long period of time. Doing so may cause damage to the scooter's electrical system and battery.
Put the cover to the battery compartment back in place. The battery can be recharged by running it for a long time. The battery may need to be replaced if the scooter doesn't start again. Your scooter battery retailer can tell you the right battery for you to use.
For more info visit: www.batteryclerk.com
Can You Jump a Moped With a Car
Source: https://batteryclerk.tumblr.com/post/100514643877/how-do-i-jump-start-my-scooter-battery